Only The Finest Available Products
Over the years we've tested many
different cooling technologies and they all had one or more things in common. They
either introduced moisture into the occupied space, the installation and
maintenance was far to complicated, or the device used far too much energy. We
searched for more than a decade for a reliable, high performance, cost effective
solar air conditioning system that we could put our name behind and found
nothing......that is until now.
The technology behind this revolutionary
system was invented by a Russian scientist with a specialty in fluid and air
dynamics, that defected to the United States about a decade ago. His patented
design has literally rewritten the books on cooling technology. Efficiencies
that were once thought to be impossible are easily achieved by these high tech
machines. The elegant yet simple design provides for a superior cooling solution
that withstands the test of time.
Incredibly a single air conditioner using his
patented technology can
cool 3,000 sq ft of building space while only using only 1/3 the power of a hair
dryer, saving you up to 90% in energy costs without adding moisture to
the conditioned space.

This product was recognized by R&D
magazine as one of the
"top 100 most technologically significantly products" introduced into the
international marketplace. Providing fresh, filtered, comfortable air from the
outside they can be sized for industrial, commercial and residential settings.
Can be used without or without solar system.
The U.S. Department of Energy reports
that this technology "has the potential to have significant impact on an
agency's energy bills in terms of reducing both energy and demand costs."
The U.S. Department of Energy also
verified these units offer an energy efficiency ratio (EER) of 40.
The California Energy Commission listed
these units as an energy efficient appliance.

How Ultracooler Air Conditioners Work

The Ultracooler air conditioner uses a thermodynamic cycle called
the Maisotsenko Cycle (M-Cycle) that capitalizes on natural, clean
energy - psychrometric energy - found in our atmosphere. This cycle
can improve any energetic or refrigeration cycle.
The patented heat and mass exchanger was developed to
economically take advantage of the M-Cycle. A heat and mass
exchanger (HMX) consists of several plates of a special plastic that
is designed to wick water evenly on one side and transfer heat
through the other side. The plates are stacked on each other,
separated by channel guides.
The purpose of the channel guides is to provide structure to the
exchanger as well as direct air movement within the HMX. The channel
guides divide the incoming air stream into product air and working
air. The product air is always separate from the working air and
stays within dry channels the entire length of the exchanger. The
product air is cooled sensibly (rejecting its heat to the working
air), and can be designed to cool below the wet bulb temperature of
the incoming air stream. The product air travels the distance of the
exchanger and into the space designated for cooling.
The working air initially enters dry channels where it is
pre-cooled sensibly before it is fractioned into multiple streams
which are directed into wet channels. The heat from the product air
is transferred to the working air in the wet channels by means of
evaporation (mass transfer and state change). The heat is exhausted
out the sides of the HMX and then to the atmosphere.
Because the heat from the product air is rejected to the working
air through heat exchange surfaces in the exchanger, the product air
only experiences sensible cooling - cooling without adding
humidity. The product air stream is completely separate from the
working air and never comes in contact with a wetted surface. This
process occurs multiple times in a short physical space within the
exchanger, resulting in progressively colder product and working air
temperatures.
The HMX system is modular, so the size and shape of a Ultracooler
air conditioner can be changed to meet user requirements. The
Ultracooler computer modeling program can be used to design for
specific needs. In addition, the product air to working air ratio
can be adjusted for a particular application.
We
Invite You To Our Facility To See For Yourself How Well This Amazing
Technology Works
Call Us
For An Appointment
1-888-955-3471